A STUDY IN MOTION
Bowlinglab.
Set the release. Follow the reaction.
Explore every moment.
DRAFT 01 Exploratory physics · not calibrated
0.00 / 7.00 s
APPROACH · RELEASE AT 0 s7.00 S
RELEASE SPEED18.0 mph
REV RATE370 rpm
PINS DOWN AT PLAYHEAD0 / 10
SIMULATION480 Hz
How the shot finder decides
Each candidate runs the same draft ball-and-pin simulation. This is a small local search, not a guaranteed strike solver.
- Respect locks. Ball, weight, hook and oil remain fixed. Checked parameters never change; unlocked parameters enter the search.
- Measure the starting shot. Candidate one is your current setup. With every parameter locked, the search stops here.
- Try nearby settings. Up to 18 runs adjust one parameter at a time, alternating plus/minus around the best result. Initial changes: 6 boards, 2° launch, 3 mph, 120 rpm, 20° rotation, 15° tilt, 4 inches loft or 30° core orientation. Each full pass halves these changes. Values snap to slider increments and stay within limits; duplicates can consume runs.
- Estimate pocket entry. The last sample before first significant ball–pin contact is projected to the headpin line. The target is 2.5 boards off center on the hook pocket side. This straight projection is an approximation, especially on misses.
- Score pinfall first. Each fallen pin earns 100 points. Headpin-first contact adds 20. Each ordered match in 1→3→5→9 (hook left) or 1→2→5→8 (hook right) adds 5; intervening contacts are allowed. Only direct ball contacts above 0.02 N·s count, not pin-to-pin chains.
- Penalize inaccurate entry. Subtract 30 times pocket error in meters (capped at 2 m), and absolute deviation from 5° entry (capped at 30°). The displayed 4–6° target is guidance, not a hard acceptance gate.
- Keep improvements only. A strictly higher score replaces the best shot; ties retain the earlier shot. The fixed budget can miss better combinations or distant solutions.
- Finish and report. Pins are counted at the final sample. After ball collection, motion must stay quiet for 0.2 s; 20 s is the simulation limit and such results are provisional. A fully guttered ball is collected after 0.4 s. Airborne releases are not captured by that rule.